Altronix PD8 Installation Instructions - Manual

PD8 - Power Distribution Module
Overview:
The PD8 power distribution module converts a single AC or DC input into eight (8) individually fused outputs.
Specifications:
Input:
• 28VAC or 28VDC up to 14 amp.
Outputs:
• Eight (8) individually fused outputs (fuses are rated @ 3.5 amp up to 5 amp fuses may be used).
• Surge suppression.
Fuse Ratings:
• Fuses are rated @ 3.5A/250V.
Visual Indicators:
• Power output LED indicator.
Additional Features:
• Power ON / OFF switch.
Board Dimensions (approximate):
5.25"L x 3.25"W x 1"H
Installation Instructions:
1. Mount PD8 in desired location/enclosure.
2. Connect the desired power supply output to terminals marked [INPUT] (Fig. 1a).
Note: If using DC voltage, left ter minal is NEG. (-) and right terminal is POS. (+) (Fig. 1a).
3. Measure output voltage before connecting devices. This helps avoid potential damage.
All terminals with common suffix P “1P, 2P...” are same polarity.
4. Set power switch [SW1] to the OFF position.
5. Connect each device to terminal pairs 1 to 8, marked [1P-1N thru 8P - 8N].
6. Output fuses rated at 3.5A/250V (Replacement fuses can be rated at 5.0 amp).
7. Set power switch [SW1] to the ON position.
N
COMMON POWER OUTPUTS
P
FUSED POWER OUTPUTS
1 2 3 4 5 6 7 8
D1
INPUT
R1
LED
SW1
O
N
O
F
F
N P S
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056
website: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.
IIPD8 - Rev. 111704
J18J MEMBER
Fig. 1
N
COMMON POWER OUTPUTS
P
FUSED POWER OUTPUTS
1 2 3 4 5 6 7 8
D1
INPUT
R1
LED
SW1
O
N
O
F
F
N P S
Neg. (--- ) Pos. (+ )
Fig. 1a