VEGA VEGAFLEX 83 Profibus PA PFA insulated User Manual

Page 22

5 Connecting to power supply

VEGAFLEX 83 • Profibus PA

44226-EN-130910

Information:

The terminal block is pluggable and can be removed from the

electronics. To do this, lift the terminal block with a small screwdriver

and pull it out. When reinserting the terminal block, you should hear it

snap in.

Proceed as follows:
1. Unscrew the housing cover
2. If a display and adjustment module is installed, remove it by turn-

ing it slightly to the left.

3. Loosen compression nut of the cable entry
4. Remove approx. 10 cm (4 in) of the cable mantle, strip approx.

1 cm (0.4 in) of insulation from the ends of the individual wires

5. Insert the cable into the sensor through the cable entry

Fig. 12: Connection steps 5 and 6 - Single chamber housing

Fig. 13: Connection steps 5 and 6 - Double chamber housing

Connection procedure