VEGA VEGAFLEX 82 Foundation Fieldbus - Manual (Page 44)

44
6 Set up with the display and adjustment module
VEGAFLEX 82 • Foundation Fieldbus
44221-EN-130910
Note:
Before the data are stored in the sensor, a check is carried out to
determine if the data fit the sensor. If the data do not fit, a fault signal
is triggered or the function is blocked. When data are being written
into the sensor, the display shows which instrument type the data
originate from and which TAG-no. this sensor had.
In this menu item you can select the type and size of your probe from
a list of all possible probes. This is necessary to adapt the electronics
optimally to the probe.
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
In this menu, you read out the instrument name and the instrument
serial number:
In this menu item, the hardware and software version of the sensor is
displayed.
In this menu item, the date of factory calibration of the sensor as well
as the date of the last change of sensor parameters are displayed via
the display and adjustment module or via the PC.
In this menu item, the identification number of the instrument in a
Foundation Fieldbus system is shown.
Additional adjustments -
Probe type
Additional adjustments -
Special parameters
Info - Instrument name
Info - Instrument version
Info - Factory calibration
date
Info - Device ID