VEGA VEGAPULS 63 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA_HART - two-wire - Manual (Page 33)

▶ B asic adjustment
D isplay
D iagnostics
S ervice
I nfo
2 S elect the menu item "Basic adjustment" with [->] and confirm with
[OK] . N
ow the menu item "Min. adjustment" is displayed.
M in. adjustment
0 .00 %
=
5 .000 m(d)
4.000 m(d)
3 P repare the % value for editing with [OK] and set the cursor to the
requested position with [->]. Set the requested percentage value
with [+] and save with [OK]. The cursor jumps now to the distance
value.
4 E nter the suitable distance value in m for the empty vessel (e.g.
distance from the sensor to the vessel bottom) corresponding to
the percentage value.
5 S ave the settings with [OK] and move to "Max. adjustment" with [-
> ] .
P roceed as follows:
M ax. adjustment
100 .00 %
=
1 .000 m(d)
2.000 m(d)
1 P repare the % value for editing with [OK] and set the cursor to the
requested position with [->]. Set the requested percentage value
with [+] and save with [OK]. The cursor jumps now to the distance
value.
2 E nter the appropriate distance value in m (corresponding to the
percentage value) for the full vessel. Keep in mind that the max.
level must lie below the dead band.
3 S ave the settings with [OK] and move to "Medium selection" with
[->] .
E ach product has different reflective properties. In addition, there are
various interfering factors which have to be taken into account:
agitated product surfaces and foam generation (with liquids); dust
generation, material cones and echoes from the vessel wall (with
solids). To adapt the sensor to these different conditions, you should
fi
rst select "Liquid" or "Solid".
Carry out max. adjust-
ment
Medium selection
VEGAPULS 63 • 4 … 20 mA/HART - two-wire 33
6 S et up with the indicating and adjustment module PLICSCOM
28436
-EN
-120530