VEGA VEGABAR 61 Foundation Fieldbus - Manual (Page 15)

For mounting, proceed as follows:
1 Position VEGABAR 61 with tube isolating diaphragm
2 Tighten the threaded fittings step-by-step once on the right and on
the left
3 Hold VEGABAR 61, to avoid distortion from the defined installation
position.
Caution:
Apart from mounting, the tube isolating diaphragm must not be
permanently under torsion.
4 Check current after mounting. The current must be between 3.9
and 4.1 mA. In case of a deviating value, losen threaded fitting and
mount again.
Information:
By slightly increasing or reducing the torque, the current can be set
exactly to 20 mA.
4.4 Mounting steps external housing
1 Mark the holes according to the following drilling template
2 Depending on the mounting surface, fasten the wall mounting
plate with 4 screws
Wall mounting
VEGABAR 61 • Foundation Fieldbus 15
4 Mounting
28258
-
EN
-081209