Appendix, Screen messages – VTech CS6124_-2-31 (without CHARGE LED) Manual User Manual
Page 48

44
Annc deleted
Your recorded announcement is deleted.
Call log empty
There are no caller ID log entries.
Directory empty
There are no directory entries.
Directory full
The directory is full.
Ended X:XX:XX
You have just ended a call.
Incoming call
There is an incoming call.
Line in use
A system handset is in use, or another telephone on the same line is
in use.
Low battery
The battery needs to be recharged.
Message deleted
The message in the answering system is deleted.
Microphone on
MUTE is turned off and the person on the other end can hear you.
Muted
You have turned off the handset microphone. The other party cannot
hear you but you can hear the other party.
New voicemail
There are new voicemail message(s) from the telephone service
provider.
No battery
No battery is installed. Follow the directions for battery installation on
page 4 to install the battery before charging.
No line
There is no telephone line connected.
No messages
There are no messages in the answering system.
Not available
One handset is already reviewing the caller ID log and the other
handset tries to review it.
Number repeated
The telephone number you enter is already stored in the directory.
Out of range or
no pwr at base
The handset cannot communicate with the telephone base. Check
the telephone base power connection or move the handset closer to
the telephone base.
Phone X:XX:XX
The handset is on a call.
Put in charger
The battery is very low. Place the handset in the telephone base or
charger for recharging.
Rec mem full
The answering system has no recording time left.
Rec mem low
The answering system has less than three minutes of recording time
left.
Record in X sec
You can record your own announcement or memo after the tone is
played.
Ringer muted
The handset ringer is muted temporarily during an incoming call.
Ringer off
The handset ringer is turned off.
Saved
Your selection has been saved.
Unable to call.
Failed phone call (the other handset is in use).
Screen messages
Appendix