VTech DS6522-3-32-4 Manual - Manual (Page 7)

3
If the handset will not be used for a long time, disconnect and remove the battery
to prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
•
•
Handset battery installation
Install the battery as shown below.
CHARGE light
remains on
when charging.
Getting started
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
orientation of the engraved label.
1. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
2.
Align the cover flat against the battery
compartment, then slide it towards
the center of the handset until it clicks
into place.
3. Charge the handset by placing it
in the telephone base or handset
charger. The CHARGE light is on
when the handset is charging.
4.
IMPORTANT:
Check for a dial tone by pressing /HOME. If you hear a dial tone, the installation
is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital
service from a cable company or a VoIP service provider, the telephone line may
need to be rewired to allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
•
•