V-Tech SC6M Manual - Manual (Page 5)

1.When SC6M working in normal, the status of LED and button operation
are as follows:
2.When SC6M working in program mode, the status of LED and button
operation are as follows:
How to enter program mode: when SC6M working in normal, press PROG
button to enter program mode. If have not any operation in ?? seconds, the
program mode will be quit automatically.
LED Indicator Description
RUN Always on
LIGHT Light on when the system connect light and it is turned on
MEMORY
- Light on when the recorded pictures is playing
- Light on first,then light off in 1s when recording pictures
CAMERA
- Light on when camera1 is working
- Blink slowly when camera2 is working
BUTTON Description
PROG Press to enter program mode
TURN ON Press to turn on the light
PLAY
When the monitor is in monitoring, press to playback the
recorded pictures in sequence, press again to play in
forword.
SWITCH
- When the montior is monitoring the view of door station,
press to switch to camera1, press again to switch to
camera2, then switch between camera1 and camera2 in
cycle.
- When the monitor is monitoring the view of camera1,
press to switch to camera2, then switch between camera1
and camera2 in cycle.
-4-