Veris Technologies Precision Rate Controller - Operation Manual - Manual (Page 8)

Pub.# OM17-PRC
2-3
Figure 12. The cab console is informing you the length of time that the drive will
be operating, in order to meter the amount of seed you have requested, at the
calibration number, planter or application width, and number of rows you have
selected. If the screen reads TIME TOO LOW, you will need to increase the
amount of seed that you will count or measure. Press Function key to advance
to next window.
Figure 13. WARNING: The drive is about to operate, meaning there is a
danger of entanglement if anyone is in the drive area. Be sure to verify that
no one is in or near the drive area before advancing to the next step.
Figure 14. Only after you have verified the drive area is clear, press the up arrow
key to initiate calibration mode. If drive area isn’t clear, press Down arrow key to
exit calibration mode.
Figure 15. Continuing to verify that the drive area is clear, press the Engage key
to start drive rotation. Pressing Function key will exit calibration mode.