Velleman projects K5201 Assembly instructions User Manual

Page 12

Text mode
Original mode



When mounting the kit in an enclosure you

should make sure the enclosure is sufficiently

insulated according to local norms.



The complete PCB is best fixed to the front panel of
the casing, so that all controls are accessible and the
LED's are visible.



Make holes in the front panel as shown in figure 3.0.



Mount the PCB on the front panel with help of the
included bushes and bolts.



Place buttons on the spindles of the potentiometer
(spindle diameter 5.9mm) and the rotary switch
(spindle diameter 6.3mm) (shorten the spindle if nec-
essary).

18. FINISHING

Finishing

All values are in mm. (1mm = 0.04")

FIG. 3.0