Velleman projects K5201 Assembly instructions - Manual (Page 11)

11

Do not use a single transformer for both units.
Make sure the ‘L’ (live) of both kits is connected to the same phase of the mains. Not doing so will result in
damage beyond repair of both kits, and the risk of fire.
Use 4mm² wire for the output section and use fuses rated as indicated.
Patterns 15 and 16 have been developed for cascade use.
Choose pattern 15 for the master unit, and pattern 16 for the slave unit.
Use :
Choose between 8 different patterns with the rotary switch SW3.
SW2 allows selection of another bank of 8 patterns.
To restart the selected pattern, press ‘RESET’
If internal speed control has been chosen (OSC. OUT connected to SIG. IN), you can adjust the running
speed with RV1.
Assembly, Hook-up & Use