TROY Group MICR_IRD 9000 1UP MICR Printing Solutions Quick-Start Guide - Manual

MICR Printing Solutions
Quick-Start Guide
Document #50-70331-001 Rev. F
Page 1 of 10
Product Installation Instructions
(For use with TROY MICR 4100, 8150, 9000, IRD 9000, and IRD 9000 1 UP Printing Solutions)
Introduction
Your TROY MICR printing solution offers value-added functionality and the flexibility to integrate smoothly
with your check-printing system. Use the TROY MICR Printing Solutions CD to install the necessary Hewlett-
Packard LaserJet printer drivers and TROY support files. To ensure successful software installation, perform
the following steps in sequential order. The documentation and installation files contained on the TROY MICR
Printing Solutions CD will be needed in the event that your TROY MICR printing solution is reinstalled in a
new location or after service has been performed. In order to best install and setup your new MICR product, use
this Quick-Start Guide and the Hewlett-Packard Getting Started Guide.
Package Contents
• TROY MICR Printing Solutions CD
• TROY MICR Printing Solutions Information Sheet
• TROY Software License Agreement
• TROY MICR Document Template
• TROY MICR Printing Solutions User’s Guide (provided in PDF format on the CD)
• TROY MICR Basics Handbook (provided in PDF format on the CD)
• TROY MICR Printing Solutions Quick-Start Guide (this document)
IMPORTANT: If you purchased a TROY DIMM Solution, please refer to the DIMM installation instructions
provided with the TROY product to install the DIMM into your Hewlett-Packard LaserJet
printer before proceeding with these setup instructions. After the TROY DIMM has been
installed in your printer, proceed to Step #2 in this document to install the required TROY
support files. In addition, a MICR toner cartridge must also be installed in your printer to
print MICR documents using the TROY DIMM Solution.
STEP 1
: Unpack and Setup the TROY Printer
1. Follow ONLY the unpacking and setup procedures described in the Hewlett-Packard Getting Started
Guide (supplied in this startup package for TROY MICR printers only), and then proceed to step #2 to
install the appropriate PCL 5e printer driver provided on the TROY MICR Printing Solutions CD. Do
NOT use the Hewlett-Packard CD to install the printer software for this installation process.
2. Be sure to install the TROY MICR toner cartridge (supplied with TROY MICR printers only) in the
same manner as described for the standard toner cartridge. The TROY MICR toner cartridge must be
installed in your TROY MICR printer or Hewlett-Packard printer in order to print MICR documents.
READ ME FIRST