Spicer IPL: Models ON or AFTER June 10, 2013 - Manual (Page 45)

43
Axle Shafts
Axle Shafts
Dana 170/190 series axle shafts are used in “sets,” and are shown as sets in the chart below. They have unequal shaft lengths and are
“location specific” and/or “Wheel Equipment specific.” When replacing the axle shafts, locate the axle shaft part number in the chart or select
the correct axle shaft using the dimensional information. Always verify part numbers before placing your order.
DO NOT MISPLACE AXLE SHAFTS FROM THEIR INTENDED LOCATION.
Axle Shafts - For Standard Models
Part No. Qty Spline Body O.D. Shaft Length Spline Length BC Dim. Flange O.D. Flange Holes
Models: D/R170, S170, S190(note 1)
131428 1 46 2.06 37.000 3.70 7.000 8.500 .948-TPR
131429 1 46 2.06 46.000 3.70 7.000 8.500 .948-TPR
131804 1 46 2.06 45.150 3.70 7.000 8.500 .773-STR
131805 1 46 2.06 36.150 3.70 7.000 8.500 .773-STR
Models: D/R190, S190, D/S590, S170E, S190E
131246 1 46 2.25 37.000 3.70 7.000 8.500 .948-TPR
131247 1 46 2.25 46.000 3.70 7.000 8.500 .948-TPR
131516 1 46 2.25 45.150 3.70 7.000 8.500 .948-TPR
131517 1 46 2.25 37.716 3.70 7.000 8.500 .948-TPR
Note 1:In some Dana approved S21-190 and S23-190 single axle applications, 2.06" body diameter axle shafts are used. Always check the
part number on the axle shaft or oem axle bom before ordering replacement parts. Aways use Dana Genuine OE approved parts for the
applications they were intended.
Axle Shaft - For Diff Lock Models
Part No. Qty Spline Body O.D. Shaft Length Spline Length BC Dim. Flange O.D. Flange Holes
Models: D/R170D, S170D, D/R190D, S190D, D590D, S590D, S190DE
131245 1 46 2.25 46.000 11.50 7.000 8.500 .948-TPR
131246 1 46 2.25 37.000 3.70 7.000 8.500 .948-TPR
131740 1 46 2.25 45.150 11.50 7.000 8.500 .948-TPR
131741 1 46 2.25 36.150 3.70 7.000 8.500 .948-TPR
131719 1 46 2.25 47.150 11.50 7.244 8.500 .948-TPR
131720 1 46 2.25 38.425 3.70 7.244 8.500 .948-TPR
131806 1 46 2.25 45.150 11.50 7.000 8.500 .773-STR
131807 1 46 2.25 36.150 3.70 7.000 8.500 .773-STR