Spicer DS404 Reinforcing Instructions - Manual (Page 6)

17.
Bracket Weld – Weld first pass, apply second or third passes as needed. When using a Mig Welder use approximate
setting of 30 volts and 180 amps. If using an Arc welder, use 1/8 inch, E7018 electrode.
Weld First Pass, Bottom of Bracket First Pass, Top Of Bracket
18. Clean and paint the repaired area.
Clean And Paint
19. Reinstall the torque rod, use same spacers.
Install Torque Rod Bracket
20. Reinstall inter axle driveline.
21. Reinstall tires and rims.
22. Reconnect grounds and oil temperature wire.
If you have any questions about this procedure call the
Spicer Call Center at 1-800-621-8084.