Soft dB Smart Piezo Drive User Guide - Manual (Page 6)

Smart Piezo Drive - User’s Manual 6
3 Software Installation
To install the high voltage amplifier software, launch the installer
SoftdB_Smart_Piezo_Drive_V130.exe and follow the on-screen instructions. At the end of the
installation procedure, the SR3Pro USB driver is automatically installed if it was not already. The high-
voltage amplifier software is located in the following folder:
C:\Program Files (x86)\SoftdB_ SoftdB_Smart_Piezo_Drive\
There are two versions of the amplifier control software:
1) USB version: Smart_Piezo_Drive.exe
2) Ethernet version: Smart_Piezo_Drive _Net.exe
The following sections describe both versions.
3.1 Control Application (USB version)
The control application allows the setup and the monitoring of the high-voltage amplifier. The following
control panel provides control over:
• Offsets
• Offset slew rate limiter
• Drift correction setup
• Channel sensitivity
• Channel gains
• Channel bandwidths