KC HiLiTES KC #341 4 LED Light System Instructions User Manual
Drivers side installed, Parts included, Assembling the brackets
Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best
engineered systems possible. Your satisfaction with our product is important, so if you have any
questions, please call our customer service line at 800-528-0950. For warranty information, visit
our website at www.kchilites.com.
PLEASE NOTE - These lights are for OFF ROAD USE ONLY
PARTS INCLUDED
4 - LED Lights
1 - Wiring Harness Kit using
Raptor Auxiliary Switch
2 - Bracket Sets w/hardware
ASSEMBLING THE BRACKETS
1. Find the two driver side
b r a c k e t s m a r k e d “ A ” .
Assemble them using one of
the 1/4” bolt, nut and washers
as shown in photo1. Assemble the two passenger
side marked “B” as shown in photo 2. Attach two
lights to each set as shown in photos 1 & 2. (Ensure
the bend is down before mounting lights.)
MOUNTING THE BRACKETS WITH LIGHTS
1. Starting with the drivers side, remove the plastic
Christmas tree clip (photo 3). Find one of the small
plates with the nut welded to it. Insert it inside the
core tube and align the nut with the hole in the tube.
Slide the bracket assembly underneath the tab
where the Christmas tree clip goes. Align the ½”
hole with the hole in the core tube and the nut plate.
Insert the ½” bolt with lock washer through the
brackets and core tube and thread into nut plate.
Replace the Christmas tree clip, align the bracket
and lights, then tighten all hardware.
WIRING YOUR LIGHTS
1. The Ford F150 Raptor has four (4) auxiliary switches
on the center console. You will be using the switch
“Aux 4” (Relay #4) . This controls a fused 10 amp
Instructions for KC #341
4 LED Light System
w/Harness for Ford Raptor
Driver Side
Front
This side
bolts to core
support tube
1/4” bolt
through
both
pieces
Bend
is down
View From Above
View From Under Vehicle
Driver
Side
Front
Feed bolt through both
brackets and core
tube then thread into
nut plate inserted
inside core tube.
Photo 1
Photo 3
Passenger Side
Front
This side
bolts to core
support tube
1/4” bolt
through
both
pieces
Bend
is down
View From Above
Photo 2
Christmas
tree clip
Hole for
Christmas tree clip
Hole for
Christmas tree clip
Drivers Side Installed
- - Continue on reverse side - -
KC3265AU - 051613
Look may vary depending
on packaged purchased.