High Lifter Lift Kit for Polaris RZR 570 (12-14) - Manual (Page 7)

6) Place the appropriate left and right brackets on either side of the shock mount tabs and
connect them using a 10x70mm bolt and 10mm lock nut.
NOTE: There are left and right rear angle brackets and left and right rear flat brackets.
When you are facing the shock from the side of the UTV the rear angle bracket will attach to
the side that is to the front of the UTV and the flat rear bracket will mount to the rear of the
UTV.
7) Next attach the round backing plate to the underside of the lower control arm buy inserting
the 10x40 hex through the backing plate, then through the lower control arm, then through
the angle lift bracket. Fasten it tight using the 10mm lock nut.