High Lifter Lift Kit for Polaris RZR 570 (12-14) - Manual (Page 3)

Front Lift Installation
1) Place ATV transmission in park. Place jack under center of UTV front end and lift until
front wheels clear the ground. Be careful to support UTV properly so that it is securely
supported so that A-arms and shocks can droop to full extension.
2) Remove front wheels.
3) Remove the bottom of the front shocks, stabilizer rod, and small spacer.
4) Place the front lift brackets onto the front shock mount. Start with the side of the shock that is
towards the front of the RZR. Insert the 10x70mm Hex bolt through the top hole on the lift
bracket. Place a 10mm washer onto the bolt, then insert the bolt through the lower shock
eyelet. Place another 10mm washer on the bolt once you push it through the eyelet.
NOTE: Make note of the angle on the bottom of the brackets. The angle helps to
clearance any welds on shock mount tabs.
5) Get the 10x110mm bolt and insert it through the large factory washer that was on the outside
of the stabilizer link. Next insert the bolt through the stabilizer link eyelet.