High Lifter SPOOL LOCKER HONDA ATV User Manual
Spool locker

High
Lifter
Products,
Inc.
(318)
524-2270
780
Professional
N.
Drive
(318)
524-2297
Shreveport, La 71105
Spool Locker
Application:
Honda 300 4x4 (All Years)
Honda 400 4x4 (All Years)
Honda 450 4x4 (98-01)
Yamaha Wolverine 350 (95-96)
Important Information
This ATV Locker is designed to replace the limited slip function of the front differential. When installed the
front tires will be effectively locked together so that all 4 wheels pull together all the time. It provides an
incredible increase in traction at a very modest cost but it does significantly increase steering effort, in forward
and reverse, particularly on hard surfaces. It also increases the distance required to turn around.
It is not appropriate for anything other than almost full time use in soft mud, by those riders who demand the
ultimate in traction who are willing to tolerate substantially increased steering effort, and for whom a Detroit
Gearless Locker is not presently feasible or desired. The ATV Locker is sold without warranty of any kind,
and High Lifter expressly disclaims responsibility for damage to property (including damage to the ATV) or
injury to persons, which may result from the buyer’s use of this product.
If upon reading this disclaimer, and before installation of the product, the buyer wishes to return it for a refund,
less shipping cost, one will be provided.
Further, if before or after installation of an ATV Locker purchased in 2003 or later, the buyer wishes to
exchange this product for credit toward a High Lifter Detroit Gearless Locker, full credit for the
invoiced purchase price will be granted, upon return of the ATV Locker
Tools Needed
Torque Wrench
Large Flathead Screwdriver
Socket (3/8” drive 6 sided 8mm Socket)
10mm, 12mm, 14mm, 17mm Sockets
Two-3ft pieces of rope or tie wire
• Caution: It is recommended that safety glasses be worn when installing the product.
• Caution: Read and comply with the manufacturer’s safety warnings and cautions.
• Caution: Do not use heat to disassemble drive axles. To do so can destroy heat treat properties of the
material, weaken or distort axle components.
1