High Lifter Max Clearance Front Forward Upper & Lower Control Arms for Polaris RZR 800 "S_"4"" - Manual (Page 3)

3
Installation Instructions:
1. Place jack under center of front end and lift until front wheels clear the ground.
Be careful to support the UTV properly so that it is securely supported but so that
A-arms and shocks can droop to full extension.
2. Remove front wheels.
3. Remove both upper and lower A-arms from the UTV. You do not need to remove
the front plastic guard completely. Just remove the two lower bolts that hold it in
place. You will be able to pull the plastic back enough that you can remove the
bolt that holds the lower control arm in place.
4. Disconnect the tie rod from the rack & pinion and from the knuckle assembly.
5. Attach the new tie rod to the rack & pinion. Run the stock nut all the way down
on the stud that sticks out from the rack. Then connect the new rod to that stud.
6. On the opposite end of the rod make sure to thread the stock jam nut on it,
running it all the way to the bottom of the threads. Do not connect to the knuckle
at this time.