How to assign player channels – EVS IPDirector Version 5.6 - May 2009 Part 1 User's Manual User Manual

Page 110

IPDirector Version 5.6 – User Manual – Part 1: General Workspace

EVS Broadcast Equipment - – May 2009

Issue 5.6.D

Each tab corresponds to one Remote P device connected.
One of the device is defined as Master, the other ones as slaves. This is done in
the Remote Installer. Refer to the Technical Reference manual.

OW TO

SSIGN

LAYER

HANNELS

You will be able to control up to four player channels with one device. To assign
player channels to the Remote P, proceed as follows:

Open the Channel Explorer.

Select the player channel and drag it to one of the four main boxes in the
Remote Control Manager window.

If needed, repeat these two steps for the three other main boxes.

The player channel name is displayed at the top of the group box.

In case the player channel is linked to other ones in a PGM/PRV mode, gang mode

or Fill and Key mode, the linked channels are listed in the Linked Channels field
and the icons corresponding to the mode (

for PGM/PRV mode,

for

gang mode,

for Fill and Key mode) are displayed next to the channels.