Concord ABSORBER XT INSTRUCTION MANUAL User Manual
Page 7
28
29
Pull the lap and diagonal belt until
it lies flat and close the harness clip
(
12
) carefully.
Push the release button (
10
) outward and
position the support leg (
11
) so that it
rests securely on the floor and the safety
display shows GREEN.
Release the control button (
10
) to lock
the support leg in place.
The shoulder strap must run through the harness clip
(
12
).
The lap harness must run over the Lap harness belt
guides (
14
) marked in red.
The seat belt must not be laid out in any other way.
The seat belts must not be twisted!
Open the harness clip for the shoulder
belt (
12
) on the side of the lap and
diagonal belt by pressing the control
button on the harness clip (
05
).
Run the lap and diagonal seat belt
between the seat part and the base of
the CONCORD ABSORBER and close
the lock of the three-point-harness.