Concord ABSORBER XT INSTRUCTION MANUAL - Manual (Page 12)

38 39
The CONCORD ABSORBER is equipped with a
removable leg support (
06 ). The leg support is located
at the front edge of the seat, and can easily be
removed by grabbing the openings on the left and right.
_ USinG THE lEG SUPPORT
The cover can be removed for washing.
Bring the seat part forward into its front-most
position and the headrest (
01 ) into its top-most
position.
Simply pull the cover straight out of its fixture!
Begin with removing the cover over the
headrest (
01 ), then take off the cover over the
seat part.
When reattaching the cover, begin with the
seat area. Stretch the cover underneath the
headrest and push the attachments into the
surrounding groove.
Now attach the cover over the headrest (
01 ).
Pull the cover upwards and over the cover
plate and then over the headrest.
Attach the cover by way of the snap fasteners
on the CONCORD ABSORBER.
• The cover material colour may run slightly
when wet, in particular during washing.
• Do not use solvents on the cover!
_ CaRE TiPS
Press the seat tilt control
(
07 ) at the front of the seat
part to tilt the CONCORD
ABSORBER.
Hold the button down and move the seat into the
desired position.
The CONCORD ABSORBER is locked in the
current tilted position when you release the seat
tilt control (
07 ).
_ USinG THE TilT aDJUSTMEnT