Concord ABSORBER XT INSTRUCTION MANUAL - Manual (Page 11)

36 37
The CONCORD ABSORBER must be adjusted to the size of the child.
Press and hold the size adjustment control ( 02 ) and
move the headrest ( 01 ) of the CONCORD ABSORBER
into the desired position.
Releasing the control button ( 02 ) will lock the
headrest ( 01 ) in its current position.
The shoulder harness guide should be situated
slightly above the child‘s shoulder. The shoulder
harnesses should lie in the middle between the
child‘s neck and the outer edge of the shoulder.
Tighten the harness by pulling the strap of the
central adjuster (
09 ) until it lies snug against the
child‘s body.
CaUTiOn!
• The seat belts must not be twisted.
• The harness lock must be locked properly and the harnesses must lie
snug against the child‘s body.
• The headrest/ harness guide must be adjusted to the size of the child and
latched securely in place.
CaUTiOn
Check the CONCORD ABSORBER for proper mounting and correct seat
belt tension, and for secure locking of all locking mechanisms before each
use.
Press the size adjustment control ( 02 ) and move the
headrest ( 01 ) of the CONCORD ABSORBER into its
top-most position.
Push the arrester of the
central adjuster upwards,
while at the same time
pulling the 5-point
harness system forward
by the lap harnesses.
Open the harness lock
and place the harnesses
to the sides and forward.
Place your child onto the seat as far back as possible.
Bring together the shoulder/ lap harnesses and the central harness in front of
the child and push the harness lock closed.
Check that the harness lock has latched shut correctly.
Ensure that none of the harness straps are twisted.
_ SECURinG YOUR CHilD in THE COnCORD aBSORBER