Concord ABSORBER XT INSTRUCTION MANUAL - Manual (Page 6)

26 27
Push the seat tilt control ( 07 ) upwards.
Press and hold the control ( 07 ) and
move the seat part of the CONCORD
ABSORBER into its forward-most
position.
The car seat must be secured with the
lap and diagonal seat belt, even if no
child is traveling in it!
Fold the support leg ( 11 ) at the bottom of the
CONCORD ABSORBER forwards until it engages.
Set down the CONCORD ABSORBER in drive
direction onto the seat or the seat bench.
The CONCORD ABSORBER should align with the
seat and backrest with as much direct contact
as possible. In vehicles with serial headrests, a
readjustment of the headrest or its removal will allow
for a better mounting position of the car seat.
Please remember to readjust or replace the headrest
in the correct position if an adult will be sitting in that
seat instead.
_ MOUnTinG THE COnCORD aBSORBER WiTH
THE THREE-POinT SaFETY BElT
With the safety of your child in mind, you have decided to purchase our car
seat CONCORD ABSORBER. The product is manufactured under strict
quality control conditions. It will only be fully effective in terms of its safety
features if used according to specifications. Please ensure strict adherence
with the mounting and usage instructions.
The fabric cover is an important component and adds to the effectiveness
of the seat; the seat may therefore only be used with an original CONCORD
cover!
The child seat can be used on any vehicle seats that are equipped with a lap
and diagonal seat belt. For reasons of results of accident statistics, however,
we recommend using the seat behind the front passenger seat.
• This product is a ‚semi universal‘ child restraint system. It has been
approved in accordance with the ECE regulation 44, change series 04
for general use in vehicles, and will fit most but not all car seats.
• This child restraint system of ECE Group I is suitable for children between
the ages of 9 months and 4 years with a body weight between
9 and 18 kg.
• This child safety restraint is compliant with the ISOFIX size category: A.
• Proper fit of the car seat can be assumed if the vehicle manufacturer
declares the vehicle suitable for the mounting of a ‚semi universal‘ child
safety restraint for the relevant age group in his vehicle manual.
• This child safety restraint was approved in accordance with the stricter
requirements of the class ‚semi universal‘ than previous models, which do
not bear this label.
• If you have any questions or doubts, please contact the manufacturer of
the child safety restraint or your retailer.
• Only suitable for use in vehicles with lap and diagonal seat belt, which are
approved in accordance with ECE regulation 16 or similar standard.
_ USinG THE COnCORD aBSORBER
_ GEnERal inFORMaTiOn