Xoro HSD 6000 - Manual (Page 158)

AMPLIFIER / DIGITAL TUNER SYSTEM
Tuning operation
Each time one frequency is spotted there will be 3 seconds
program broadcasting from it, and then the searching
goes on to the next frequency searching until the digits 1 to
10 used up (AM and FM each).
Under MANUAL MODE for both AM and FM, press FWDor
REV to tune in up to a higher frequency or downward to a
lower frequency, up to 40 frequencies broadcasting (AM
and FM each) can be tuned in and kept in correspondence
with the digitals 1 to 20. Each time one frequency is going
to be spotted, the OSD appears e.g.:
It also appears on the VFD:
When the digit 2 pressed and press again the FREQ goes
up higher to 603KHz, OSD appears:
Also the VFD appears:
The program of the frequency spotted goes to broadcast. With the same way above go on to do the
next frequency searching. To get an optimum of receiving broadcast you can press
or for a fine
frequency adjustment of the program broadcasting, and the result of which can be kept by pressing
ENT on the remote control.
After saving you can run any digit of 1~20, in each of which one FREQ frequency broadcasting has
been saved, to listen to the broadcast of the AM Or FM frequencies corresponding with what you have
ever saved.
1. You can save up to 40 frequencies, FM and AM each.
2. Machine will save the frequencies re-cycle.
3. VFD of the machine will display the saved message being played when the TUNER is on.
4. The FM frequency range: 87.5 108MHz
Frequency-step = 50KHz
The AM frequency range: 530-1600KHz
Frequency-step = 10KHz
Notes:
t u
- - TUNER MENU - -
AM MODE
STATION
FREQ
MODE
1
101.7 MHz
MANUAL
- - TUNER MENU - -
AM MODE
STATION
FREQ
MODE
2
603 KHz
MANUAL
AM 1 540 KHz
INPUT STATION
SAVE TO 2
SAVE TO 2
158