AASTRA 620d for Aastra 400 User Guide EN - Manual (Page 62)

Supplementary features
62
eud-1291/1.0 – R1.0 – 01.2011
Setting functions by remote control
This section explains how you can alter your phone’s settings even if you are not
directly at your phone.
You are not at your desk and want to set various functions on your phone from a dif-
ferent phone.
You can activate/deactivate many of your phone's functions by remote control from a
different phone.
The remote control is initiated using a special */# procedure. You can then enter the
function commands and */# procedures.
Using remote control from a third-party phone:
1. Enter procedure #36.
2. Enter your phone number.
3. Enter your PIN.
4. Enter the */# procedure for activating/deactivating the function you want.
Press the Call key.
➔
Acknowledgement tone sounds; function is activated/deactivated.
Note:
The default PIN setting "0000" is not accepted. First change the PIN as
described in chapter
"Changing the User PIN" , page 76 or use */#
procedure *47 (see "User’s Guide */# Procedures" on the Aastra document
portal:
www.aastra.com/docfinder ). If you have forgotten your PIN, your system
administrator can reset it to the default setting.