American Magnetics 188CPS Point-Sensing Instrument - Manual (Page 15)

14
Installation
Configuring power
7. Connect the instrument to the appropriate power receptacle
Warning
The Model 188CPS operates on 50-60 Hz power and may be configured for
115 or 230 VAC (100 or 200 VAC for Asian markets). The power requirements
for each instrument is marked on the calibration sticker on the bottom of the
instrument. Be sure your instrument is configured for your power source prior
to plugging in the line cord. Do not fail to connect the input ground terminal
securely to an external earth ground.
Ensure the front panel switch is in the OFF position. Verify that the instrument is
configured for the proper operating voltage by referring to the calibration sticker
affixed to the bottom of the instrument. If the operating voltage is correct, plug the line
cord into the appropriate power receptacle.
If the instrument operating voltage needs to be changed, ensure the instrument is de-
energized by disconnecting the power cord from the power source. Remove the
instrument cover and slide the voltage selector switch on the main printed circuit
board to the proper voltage. Replace the instrument cover.