ACU-RITE 100S - Manual (Page 30)

100S Reference Manual 27
Recommended
Corrective Action
Decimal point
scrolls across
display Press any key or move the
table to return to the previ-
ous screen. System has been idle
for approximately 90
minutes and is in
“display saver”
mode
Symptom Probable Cause
Screen is
blank Check that the power
switch on the back of the
console is “on.” No power to the
readout
Check that the readout’s
power cord is properly
connected to the power
supply.
Check that the power
source meets the specifica-
tions required by your
system (pg. 33).
Contact your 100S distrib-
utor for repair/
replacement procedures.
LED failure
Dashes
appear on
screen The value entered exceeds
the display’s 8-character
capability. Enter a value
with less than 8
characters.
(cont’d next page) Display overflow
Check the fuse. (Located
above the power switch).
TROUBLESHOOTING