Operation, Centerline – ACU-RITE 100S User Manual
Page 23
![background image](/manuals/248937/23/background.png)
20
OPERATION
100S
Reference Manual
Centerline
With
100S
, you can find the centerline (midpoint) between any two
positions on your part. You can establish centerline as your datum by
using absolute dimensions or you can create a centerline using
incremental measurements without affecting your current datum.
Refer to “Setting the Datum (Absolute Zero)” on pg. 13.
Setting the Datum on a Centerline
1. Press the
ABS/INCR
key until ABS is selected.
2. Move the table to the first location.
3. Press the
ZERO
key twice for the axis (X, Y, or Z) you want to find
the centerline.
4. Move the table to the second location along the same axis.
5. Press the
C/L
(centerline) key. Dashes will flash on the screen.
6. Press the appropriate key (
X
,
Y
, or
Z
) for the axis you’re measuring.
7.
100S
will measure the distance between the two points,
then divide the sum in half. You can locate the centerline by moving
the table until the position for the axis you measured reads “0.”
Repeat the procedure to locate the midpoint for multiple axes. An
example appears on the next page.