Acura 2009 RDX - Manual (Page 361)

CONTINUED
Examine the new wiper blades. If
they have no plastic or metal
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade, and install them in
the slots along the edge of the new
blade. Install the new blade onto the
blade assembly: Remove the blade from the blade
assembly:
Pull out the blade by grabbing
the end of it as shown in the
above illustration.
Find two tabs with a ‘‘SET’’ and
‘‘
’’ mark on the wiper blade
assembly. The opposite side of
the ‘‘
’’ mark is the direction
you pull out the wiper blade.
Find two tabs with a ‘‘SET’’ and
‘‘
’’ mark on the wiper blade
assembly. This is the direction
you install.
Slide the blade onto the
assembly until it is locked by the
tabs.
5. 3. 4.
Wiper Blades
Ma
int
e
na
nce
357
REINFORCEMENT
BLADE
BLADE
TABS
2009 RDX
Table Of Contents Main Menu