Acura 2010 TL - Manual (Page 449)

Remove the fuel fill cap slowly.
You may hear a hissing sound as
pressure inside the tank equalizes.
Place the cap in the holder on the
fuel fill door.
Your vehicle’s on board diagnostic
system will detect a loose or missing
fuel fill cap as an evaporative system
leak. The first time a leak is detected
a ‘‘TIGHTEN FUEL CAP’’ message
appears on the multi-information
display.
The fuel fill cap is attached to the
fuel fill door with a tether to avoid
losing the cap.
Stop filling the tank after the fuel
nozzle automatically clicks off. Do
not try to ‘‘top off’’ the tank. This
leaves some room in the fuel tank
for the fuel to expand with
temperature changes.
even
though the tank is not full, there may
be a problem with your vehicle’s fuel
vapor recovery system. The system
helps keep fuel vapor from going
into the atmosphere. Try filling at
another pump. If this does not fix the
problem, consult your dealer.
Push the fuel fill door closed until
it latches.
Screw the fuel fill cap back on
until it clicks at least once. If you
do not properly tighten the cap,
you will see a ‘‘TIGHTEN FUEL
CAP’’ message on the multi-
information display. If the system
still detects an evaporative system
leak after retightening the cap, the
malfunction indicator lamp may
come on (see page
).
3.
4.
5.
6.
560
If the fuel nozzle keeps clicking off
Service Station Procedures
Tighten Fuel Cap Message
446
TETHER
FUEL FILL CAP
HOLDER
09/07/29 18:12:50 31TK4610_451
2010 TL