Acura 2013 ZDX - Manual (Page 78)

76
uu Indicators u
In
st
ru
men
t P
a
ne
l
Indicator Name On/Blinking Explanation Message
SH-AWD® (Super
Handling-All
Wheel Drive
TM )
Indicator
● Comes on for a few seconds when
you set the power mode to ON, then
goes off.
● Comes on if there is a problem with
the SH-AWD® system.
● Blinks when the differential
temperature is too high.
● Stays on constantly –the engine
drives the front wheels only in this state.
Have the vehicle checked by a dealer.
● Blinks while driving – Stop in a safe
place, shift to P, and idle the engine
until the indicator goes off. If the
indicator does not stop blinking, take
your vehicle to a dealer.
2 SH-AWD® (Super Handling-All
Wheel Drive TM ) P. 204
BSI (Blind Spot
Information)
Indicator
● Comes on for a few seconds when
you change the power mode to ON,
then goes off.
● Stays on while BSI is turned off.
● Comes on when mud, snow, or ice
accumulates in the vicinity of sensor.
● Comes on if there is a problem with
the system.
—
● Comes on while driving - Remove
the obstacle in the vicinity of sensor.
● Comes on while driving - Have the
vehicle checked by a dealer.