Acura Embedded AcuTab-M7 - Manual (Page 8)

Activate Wi-Fi function Activate Bluetooth function
Activate WWAN function Activate GPS function
Powering on for the first time
The Power/Resume button is found on the left side of the Tablet PC. Press the
Power/Resume button to start your system and check that if the Power LED turns on.
After a few seconds, the system’s display to execute the Power On Self Test or POST to
check if all system components are running properly. Any error found during the test will
be displayed on the screen.
After the test, the screen will also display a message "press to enter SETUP".
You don’t need to run this program at the the necessary settings for your computer
optimal operation.
After the test has completed, your computer will start to search and boot up the
operating system from your hard drive.
Before setting up the system, please make sure the following items are available.

Keyboard
 Mouse (for system software installation)
A keyboard is an input device; a mouse is a pointing device. Please connect these two
devices as graphics shown below to interact with your system.
Using the External Audio System
At the right side of AcuTab-M7, you will find the headphone jack for connecting 3.5mm
4-conductor TRRS (stereo-plus-mic) headphone jack.
Bios Setup Program
This system comes with a chip from Phoenix BIOS that contains the ROM Setup
information for your system. (This chip serves as an interface between the processor and
the rest of the system components.) This section explains the information contained in the
Setup program and tells you how to modify the settings according to your system
configuration.
The Setup utility program allows updates to the main board configuration settings. The
BIOS setup values will be saved in the CMOS. It is executed when you change the
system configuration, you change the system backup battery, or the system detects a
configuration error and asks you to run the Setup program. You must have connected a
USB type of keyboard, and Use the arrow keys to select, and press Enter to run the
selected program.
Function Key
Please check the following table for the function description of each direction key.
Function Key (s) Function Description

Moves cursor left to select Screens

Moves cursor up or down to select items /
+ / -
To change option for the selected items
To bring up the selected screen
To display the General Help screen
To save changes and exit the BIOS
SETUP UTILITY
To jump to the Exit Screen or exit the
current screen
Main Screen Setup Utility
When you enter the BIOS SETUP UTILITY, the Main screen will appear and display the
system overview.
15
14