Pc 8120, Inch core 2 duo touch panel pc – Acnodes PC 8120 User Manual

Page 51

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

PC 8120

12-inch Core 2 Duo touch panel PC

Do Calibration

1. To adjust the touch screen mapping properly to display screen, use PM.BAT (C:\PENMOUNT\PM) to do calibra-

tion. Chose “1” DO CALIBRATION (adjust screen mapping).

2. The message pops out to ask if you select the video mode number. Use keyboard to select starting the calibra-

tion, touch the uppercenter pint, then right-center point, bottom-center point, and left-center point in sequence. After the
calibration is done, the data will be shown on the screen, then press any key to continue the progress.

3. After the calibration, you are suggested to test the touch screen and display mapped results by choosing “3”

DRAWING TEST under PM.BAT

Initializing The PenMount Driver

If you don’t have the initialization commands in AUTOEXEC.BATm initialize PenMount C:\PENMOUNT\PMINIT)

controller before you use the PenMount Touch Screen. The display will show the initialization message:

PenMount: V7.06 Copyright(c) SALT International Corp.
Test: COM IRQ is the number after PMDETECT done)
Penmount communication settings: COM IRQ Baud Rate:

Demonstration

To demonstrate or test touch screen operation, please select “3” DRAWING TEST in PM.BAT file of the Utility

Directory. Drawing will be shown on the screen. The demonstration program “ICECREAM.EXE.” in the “PENMOUNT”
directory can be applied, too.