Acnodes OPC 8190 - Manual (Page 65)

4.2 Touch Screen
The FDK uses the 5-wire analog resistve. There are the
specification and driver installation which are listed below.
4.2.1 Specification
Touch Screen 5-wire Analog Resistive type
Touch Screen Controller PenMount 6000 USB
Touch Screen Controller IC
Communications USB interface
Baud Rate 19200 baud rate fixed
Resolution 1024 x 1024 (10 bit A/D converter inside)
Power Input 5V
Power Consumption
Active: 24.6mA / Idle Mode: 13.4mA
4.2.2 Driver Installation- Windows XP
The FDK provides a touch screen driver that users can install it under
the operating system Windows XP. To facilitate installation of the touch
screen driver, you should read the instructions in this chapter carefully
before you attempt installation.
1. Insert Driver CD and follow the path to select the “\Drivers\Step 5
- Touc h”.
2. Follow the installing procedure and press OK.