Rmc 7130, 4 drive bay installation/removal – Acnodes RMC 7130 User Manual

Page 64

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

RMC 7130

1U Rackmount System

6-4

Drive Bay Installation/Removal

Accessing the Drive Bays

For installing or removing a DVD-ROM or Serial ATA drive, you will need to gain access to the inside
of the RMC7130 by removing the top cover of the chassis. The DVD-ROM drive is an optional compo-
nent in the server.

SATA Drive Installation

The SATA drive is not hot-swappable, meaning system power must be turned off before installing or
removing.

1. First power down the system and unplug the AC power cord.

2. Remove the top cover of the chassis.

3. Unscrew the retention screw at the corner of the DVD-ROM module and the four retention screws
through the bottom of the chassis. Remove the DVD- ROM module/drive.

4. Remove the drive tray from the chassis.

5. To add a new SATA drive, install a drive into the tray with the printed circuit board side facing
down and so that the mounting holes align with those in the tray. Secure the drive to the tray with the
four screws.

6. Replace the DVD-ROM drive and the top cover when finished.

DVD-ROM Drive Installation

The optional DVD-ROM drive must have a "slim" profile to fit into the 5016T- MRB/5016T-MR-LN4B.
The drive is installed into a module that fits into place in the chassis.

1. First power down the system and unplug the AC power cord.

2. Remove the top cover of the chassis.

3. Remove the retention screw at the rear right corner of the DVD-ROM module.

4. Remove the DVD-ROM module from the chassis.

5. Attach the side rails and backplane PCB to the DVD-ROM drive (see Figure

6-5.)