Rmc 7130 – Acnodes RMC 7130 User Manual

Page 24

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

RMC 7130

1U Rackmount System

3. Next, depress the two buttons on the top of the chassis to release the top cover while pushing the cover
away from you until it stops. You can then lift
the top cover from the chassis to gain full access to the inside of the server.

Checking the Components

1. You may have one processor already installed into the system board. The processor should have its
own heatsink attached. See Chapter 5 for instruc- tions on processor installation.

2. Your system may have come with system memory already installed. Make sure all DIMMs are fully
seated in their slots. For details on adding system memory, refer to Chapter 5.

3. If desired, you can install an add-on card to the system. See Chapter 5 for details on installing a PCI
add-on card.

4. Make sure all power and data cables are properly connected and not block- ing the airflow. See Chap-
ter 5 for details on cable connections. Also, check the air seals for damage. The air seals are located under
the blower fan and beneath the frame cross section that separates the drive bay area from the
motherboard area of the chassis.