Rmc 7130 – Acnodes RMC 7130 User Manual

Page 50

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

RMC 7130

1U Rackmount System

Universal Serial Bus (USB)

There are two Universal Serial Bus ports located
on the I/O panel. An additional six USB headers
are in- cluded on the board, which may be used for
front side access (cables not included). USB 6 and
USB 7 are "Type A" connectors. See the table on
the right for pin definitions.

SGPIO Headers

The SGPIO (Serial General Purpose Input/Output)
headers are used to communicate with an enclo-
sure man- agement chip on the backplane. The T-
SGPIO headers are for SATA and the 3-SGPIO
headers (X8STi only) are for SAS configurations.
See the table on the right for pin definitions.

Power Supply SMBus Header

A Power SMB header is located at SMB_PS1.
Connect the appropriate cable here to utilize
SMB on your system. See the table on the right
for pin definitions.

LAN1/2 (Ethernet Ports)

The Ethernet ports (LAN1 and LAN2, plus LAN3
and LAN4 on the X8STi- LN4) are located beside
the VGA port on the I/O backplane. These ports
accept RJ45 type cables.