Pc 5150, Pc 8153 – Acnodes PC 8153 User Manual
Page 46
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
PC 5150
15-inch touch panel PC
46
PC 8153
15-inch touch panel PC
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218,
Identify the Communication Port and IRQ Number
1. For the first time installation, or changing Pen Mount Touch Screen's COM port, use PMDETECT (e.g. C:\PEN
MOUNT\PMDETECT) to check the COM port and IRQ number. PMDETECT will save the correct data to PMOUSE.CFG file for
further use.
2. The driver detects your communication COM port and IRQ number from COM1 IRQ4, COM2 IRQ3, COM3…. to COM4
IRQ15. Pen mount driver can find the COM port and IRQ number automatically. The screen will then show:
Pen Mount is initialized successfully!!! Create file "pmouse.cfg". Success. Pen Mount internal settings: Comm. Port: COM
IRQ
3. PMDETECT program is able to skip the IRQ number detecting if the Touch screen Driver Installation 13 does not need to
detect the specified IRQ number. For example, you do not need to detect IRQ5, and the command is: C:\PEN
MOUNT\PMDETECT -N5
4. If you do not need to detect IRQ5 and IRQ9, the command is: C:\PEN MOUNT\PMDETECT -N5 -N9
Do Calibration
1. To adjust the touch screen mapping properly to display screen, use PM.BAT (C:\PEN MOUNT\PM) to do calibration.
Choose "1" DO CALIBRATION (adjust screen mapping).
2. The message pops out to ask if you select the video mode number.
Use keyboard to select starting the calibration, touch the upper- center point, then right-center point, bottom-center point and
left- center point in sequence. After the calibration is done, the data will be shown on the screen, then press any key to con-
tinue the progress.
3. After the calibration, you are suggested to test the touch screen and display mapped results by choosing "3" DRAWING
TEST under PM.BAT
Initializing the Pen mount Driver
If you don't have the initialization commands in AUTOEXEC.BAT, initialize Pen mount C:\PEN MOUNT\PMINIT) controller before
you use the Pen mount Touch Screen. The display will show the initialization message:
Pen mount V7.06 Copyright(c) SALT International Corp. Test:COM
Pen mount communication settings: COM
Demonstration
To demonstrate or test touch screen operation, please select "3" DRAWING TEST in PM.BAT file of the Utility Directory.
Drawing will be shown on the screen. The demonstration program "ICECREAM.EXE" in the "PEN MOUNT" directory can be
applied, too.