Accusys ACS-75130 - Manual (Page 6)

English - 6
System Requirements
The 7500 can be installed inside a computer that meets the
following hardware specifications:
System with IDE/AT interface
Case with two half-height 5 ¼” drive bays with front bezel
access
One IDE channel cable connector
One free power supply connector
Front Panel Components
Top drive
carrier
Bottom drive
carrier
Rebuilding
activity / Error
message indicator
Disk activity indicators
Disk activity indicators
Disk status / Rebuild
indicators
Top Drive carrier lock
Bottom Drive carrier lock
About Drive Carriers:
Each drive carrier can hold a one-inch high 3.5-inch form
factor IDE disk drive. This makes it easy to hot swap a drive
in the event of a failure, without affecting the status of the
remaining drive.
Indicators
Disk Activity Indicators
These indicators show the status of each individual disk drive.