beautypg.com

Osd screen functions (continued), Configuration1, English – MITSUBISHI ELECTRIC MDT552S User Manual

Page 57

background image

English-53

English

Enlarged

90%

Motion

Move

The portion (shaded part) outside the
display area isn’t displayed.

OSD screen functions (continued)

CONFIGURATION1

AUTO SETUP

* For the D-SUB inputs only.

The screen size, horizontal/vertical position, clock, clock
phase, and input signal level are automatically adjusted.

AUTO ADJUST

* For the D-SUB inputs only.

When AUTO ADJUST is ON, the horizontal position, vertical
position, and clock phase are automatically adjusted at the
time of the timing switching.

POWER SAVE

When the power saver in the OSD menu is turned ON, the
power management function works.
RGB:

When the sync signal of computer input (HDMI1,
HDMI2, DVI-D, D-SUB, or DISPLAYPORT) is
terminated, the monitor will be in the sleep mode in
several seconds.

VIDEO: When the sync signal of video input (YPbPr,

S-VIDEO, or VIDEO) is terminated, the monitor will
be in the sleep mode in approximately 10 minutes.

NOTE: When an expansion module is in the option slot,

this function is invalid and the monitor doesn’t enter
the sleep mode even when you set this function to
ON. Even when you select other image source, the
monitor doesn’t enter the sleep mode.

LANGUAGE

OSD control menus are available in eight languages.
(English, German, Spanish, French, Italian, Swedish,
Chinese, and Japanese)

SCREEN SAVER

You can set the SCREEN SAVER functions to reduce the
risk of “image persistence.”
GAMMA:
When you select ON, the gamma mode where image
persistence is diffi cult to occur is used.
COOLING FAN:
When you select ON, the cooling fan always runs.
When you select AUTO, the built-in fan automatically starts
running according to the operating temperature.
BRIGHTNESS:
When you select ON, the brightness decreases.
MOTION:
The screen slightly moves horizontally and vertically
at regular intervals to reduce the effect of the image
persistence.
NOTE: While TILING in the ADVANCED OPTION menu is

active, you cannot set MOTION to ON.

When you select a time period in the MOTION
setting, the monitor enlarges the image and moves it
horizontally and vertically. The portions of the image
out of the display area aren’t visible.

To make the entire image visible all the time, arrange
it to fi t within 90% of the screen area at the center.

COLOR SYSTEM

* For the S-VIDEO and VIDEO inputs only.

You can select the color system depending on the video
device you use.
AUTO:

NTSC, PAL, SECAM, PAL-60 or 4.43 NTSC is
automatically selected.

NTSC: NTSC
PAL: PAL
SECAM: SECAM
4.43NTSC: 4.43

NTSC

PAL-60: PAL-60
NOTE: When you use a video device purchased from

overseas, set the COLOR SYSTEM menu.

SIDE BORDER COLOR

You can adjust the brightness of the area where no images
are displayed when a 4:3 image is displayed in the NORMAL
mode in the ZOOM MODE or the POP or other modes in the
PIP MODE.

CONFIGURATION RESET

The settings made in the CONFIGURATION1 and
CONFIGURATION2 menus are reset to the factory defaults.
However, the LANGUAGE, MONITOR ID, SCHEDULE, and
DATE AND TIME settings aren’t reset.

FACTORY RESET

The settings made in the PICTURE, SCREEN, AUDIO,
CONFIGURATION1, CONFIGURATION2, and ADVANCED
OPTION menus are reset to the factory defaults.
In addition, the picture mode selected by the wireless
remote control is reset to the factory default.
However, LANGUAGE, CONTROL TIME OUT, MONITOR ID,
SCHEDULE, DATE AND TIME, and DDC/CI aren’t reset.