Eizo FlexScan HD2442W - Manual (Page 9)

7
English
Troubleshooting Setting/Adjustment Installation Prior to use
Using the Operation Switch
Operation switch
• There are three methods of
operation:
- Tracing the slide bar
 Turning the power On/Off
 Displaying/Quitting a menu
Setting menu
Shortcut menu
(When the menu is not displayed on the screen)
 Selecting a menu item/Setting and Adjusting
The increase/decrease speed of the
adjustment value may change
depending on the tracing speed of the
slide bar.
At fine adjustment
Tapping once changes the adjustment value to one step up or down.
Touching the slide bar continuously may change the value serially.
 Fixing an item
Deciding the setting and adjusting value
Power Off: Touch .
Power On: Touch any of the keys to turn on the monitor.
Tap
Touch .
Touch the slide bar.
Trace the slide bar left and right.
Tap either end of the slide bar, marked with and .
Tap the slide bar.
 Switching the Input Signal
Each time you tap the switch, the
input signal switches to the other.
- Touching the switch
- Tapping the slide bar
• The operations with the slide
bar (selecting, setting, adjusting,
fixing and deciding items) can be
performed with the remote control.
* When the signal is not input,
even if the contents of the menu
have been changed, the menu of
"Volume" is displayed.
By touching the switch for 5 seconds, the contents of the menu changes
as follows: "Volume" → (touching for 5 seconds) →"Color Mode" →
(touching for 5 seconds) → "Brightness".*