Shure MX153 - Manual (Page 2)

Certifications
Eligible to bear CE Marking. Conforms to European EMC Directive
2004/108/EC. Meets Harmonized Standards EN55103-1:1996
and EN55103-2:1996, for residential (E1) and light industrial (E2)
environments.
The CE Declaration of Conformity can be obtained from: www.shure.
com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: [email protected]
Note: Information in this guide is subject to change without notice.
For additional information about this product, please visit www.
shure.com.
Specifications
Transducer Type Electret Condenser
Polar Pattern Omnidirectional
Frequency Response 20 to 20,000 Hz
Output Impedance N/A
Sensitivity
open circuit voltage, @ 1 kHz, typical -41 dBV/Pa [1] (9 mV/Pa)
Maximum SPL
1 kHz at 1% THD
[2]
2500 Ω load: 107 dB SPL
1000 Ω load: 107 dB SPL
Signal-To-Noise Ratio [3] 60 dB
Dynamic Range
@ 1 kHz 2500 Ω load: 73 dB
1000 Ω load: 73 dB
Self Noise
equivalent SPL, A-weighted, typical 34 dB
Common Mode Rejection
20 to 20,000 Hz N/A
Operating Temperature Range -18°C (0°F) to 57°C (135°F)
Polarity Positive pressure on diaphragm produces
negative voltage on pin 3 with respect to pin
1.
Power Requirements +1–5 V DC (500 µA max.)
Weight 19.76 g
1 Pa=94 dB SPL
THD of microphone preamplifier when applied input signal level is equivalent to cartridge output at
specified SPL
S/N ratio is the difference between 94 dB SPL and equivalent SPL of self noise, A-weighted
20
15
10
5
0
-5
-10
-15
-20
20 100 1k 10k 20k
dB
FREQUENCY (Hz)
1219.2 mm
(48 in.)
GREEN
SHIELD
PIN 2
PIN 3
PIN 1
2.2K Ω
1 uF 10V
ECM
FET
CAPSULE OVERMOLD
BOOM
TUBE
SHIELDED
CABLE
CASE
CONNECTOR
PIN 4 N/C