beautypg.com

Shure Wl185 User Manual

Wireless lavalier microphones user guide, General, Applications

background image

Wireless Lavalier Microphones

User Guide

©

2005, Shure Incorporated

27C2833 (Rev. 4)

Printed in U.S.A.

Models WL183, WL184 and WL185

GENERAL

Models WL183, WL184 and WL185 are lavalier electret condenser

microphones for use with a wireless bodypack transmitter. Each micro-
phone has a 1.2 meter (4 ft.) cable terminated with a miniature 4-pin con-
nector (TA4F). The furnished tie clip can be rotated in 90! intervals for
placement flexibility.

APPLICATIONS

WL183 (Omnidirectional): General purpose sound reinforcement,

recording, or remote monitoring applications. Low handling noise. Pickup
angle is 360!.

WL184 (Supercardioid): Sound reinforcement applications requiring

high rejection of ambient noise and narrow pickup angle. Use of wind-
screen highly recommended. Pickup angle is 115!.

WL185 (Cardioid): General purpose sound reinforcement applica-

tions requiring good rejection of ambient noise. Use of windscreen highly
recommended. Pickup angle is 130!.

INSTALLATION

1. Insert the top of the microphone through tie clip loop from below until

tie clip loop snaps into place over the lower groove on the micro-
phone. Refer to the following illustration.

2. To install the snap-fit windscreen, press it

down on the microphone until it clicks into
place inside the upper groove on the micro-
phone. The snap-fit windscreen provides 30
dB of pop protection.
NOTE:

The snap-fit windscreen can be removed

by spreading the slot in the plastic snap-

fit ring.

To install the smaller foam windscreen,

slip the windscreen over the top of the mi-

crophone so that it covers the side slots.

The foam windscreen provides 5 to 10 dB of pop protection.

3. Attach the microphone approximately 76 mm to 152 mm (3 to 6 in.)

below the neckline.
NOTE: Do not cover the microphone with your hand or clothing.

CHANGING CARTRIDGES

The WL183, WL184, and WL185 microphones use interchangeable

cartridges. To change the cartridge, unscrew it from the microphone base
and replace it with one of the replacement cartridges listed below.

REPLACEMENT PARTS AND ACCESSORIES

Omnidirectional Cartridge ......................................... R183B
Supercardioid Cartridge ........................................... R184B
Cardioid Cartridge..................................................... R185B
Snap-fit Windscreens (4) .....................................RK183WS
Foam Windscreen (4) ..........................................RK261WS
Tie Clips (2)........................................................... RK183T1
Miniature 4-pin Connector.........................................WA330

SPECIFICATIONS

Type: Condenser (electret bias)
Frequency Response: 50 to 17,000 Hz

Polar Patterns (at 1 kHz): (see below)

Output Impedance : 1800

"

Sensitivity (1 Pa = 94 dB SPL): ........... WL183: -40.0 dBV/Pa

............................................................... WL184: -44.5 dBV/Pa
............................................................... WL185: -45.5 dBV/Pa

Maximum Sound Pressure Level:...... WL183: 125.0 dB SPL

.............................................................. WL184: 129.5 dB SPL
.............................................................. WL185: 130.5 dB SPL

Output Noise (A-weighted): ................. WL183: 22.5 dB SPL

................................................................ WL184: 27.0 dB SPL
................................................................ WL185: 28.0 dB SPL

Dynamic Range: 102.5 dB
Polarity: Positive pressure on diaphragm produces positive voltage
on pins 3 and 4 relative to pin 1.
Power Requirements: Regulated nominal +5 Vdc (1.5 Vdc to 10
Vdc) provided at microphone connector pin 2 relative to pin 1 of a
Shure wireless microphone transmitter.

WINDSCREEN

TIE CLIP

MICROPHONE

500

1,000

2,000

5,000 10,000

50

100

200

20

20,000

500

1,000

2,000

5,000 10,000 20,000

50

100

200

20

0

+10

–10

0

+10

–10

0

+10

–10

500

1,000

2,000

5,000 10,000

20,00

50

100

200

20

dB

Hz

dB

Hz

dB

Hz

WL183 FREQUENCY RESPONSE

WL184 FREQUENCY RESPONSE

WL185 FREQUENCY RESPONSE

–10 dB

–15 dB

–5 dB

–20 dB

150°

120°

150°

120°

180°

30°

60°

90°

30°

60°

90°

CARDIOID

(WL185)

OMNIDIRECTIONAL

(WL183)

SUPERCARDIOID

(WL184)

–10 dB

–15 dB

–5 dB

–20 dB

150°

120°

150°

120°

180°

30°

60°

90°

30°

60°

90°

–10 dB

–15 dB

–5 dB

–20 dB

150°

120°

150°

120°

180°

30°

60°

90°

30°

60°

90°

1

3

2

CONDENSER

CARTRIDGE

IMPEDANCE CONVERTER

G

SHIELD

BLK

RED

S

D+

4

MICROPHONE WIRING DIAGRAM

1 GROUND

2 BIAS

3,4 AUDIO