Microlife BP 3BEO-4 - Manual (Page 9)

• If the blood-pressure monitor is left unused for long periods, please remove the batteries
from the device.
Functional check: Hold on the O/I button down to test all the display elements. When functioning
correctly all segments must appear.
4.2. Reading the set date
Please press the Time button.
4.3. Setting the time and date
1)
After the new batteries are fitted, the year number flashes in the display. You can set the
year by pressing the M-button. To confirm and then set the month, press the Time button.
2) You can now set the month using the M-button. Press the time button to confirm and then
set the day.
3) Please follow the instructions above to set the day, hour and minutes.
4) Once you have set the minutes and pressed the Time button, the date and time are set and
the time is displayed.
5) If you want to change the date and time, press and hold the Time button down for approx.
3 seconds until the year number starts to flash. Now you can enter the new values as
described above.
5. Carrying out a measurement
5.1. Before the measurement
•
Avoid eating, smoking as well as all forms of exertion directly before the measurement. All
these factors influence the measurement result. Try and find time to relax by sitting in an
armchair in a quite atmosphere for about 5 minutes before the measurement.
• Measure always on the same wrist (normally left).
•
Attempt to carry out the measurements regularly at the same time of day, since the blood-
pressure changes during the course of the day.
5.2. Common sources of error
Note: Comparable blood-pressure measurements always require the same conditions!
These are normally always quiet conditions.
•
All efforts by the patient to support the arm can increase the blood pressure. Make sure you
are in a comfortable, relaxed position and do not activate any of the muscles in the
measurement arm during the measurement. Use a cushion for support if necessary.
6