Edimax Technology 3G-6200n - Manual (Page 55)

54
segment
802.1d
Spanning Tree
Disabled
If 802.1d Spanning Tree function is
enabled, this router will use the
spanning tree protocol to prevent
from network loop happened in the
LAN ports.
DHCP Server Enabled
You can enable or disable the DHCP
server. By enabling the DHCP server
the router will automatically give your
LAN clients an IP address. If the
DHCP is not enabled then you’ll have
to manually set your LAN client’s IP
addresses; make sure the LAN Client
is in the same subnet as this
broadband router if you want the
router to be your LAN client’s default
gateway
Lease Time
When enabled, DHCP service will
temporarily give your LAN clients an
IP address. In the Lease Time setting
you can specify the time period that
the DHCP lends an IP address to
your LAN clients. The DHCP will
change your LAN client’s IP address
when this time period is reached
IP Address Pool
You can select a particular IP address
range for your DHCP server to issue
IP addresses to your LAN Clients.
Note: By default the IP range is from:
192.168.2.100 to 192.168.2.200. If
you want your PC to have a
static/fixed IP address then you’ll
have to choose an IP address outside
this IP address Pool.
Domain Name
You can specify a Domain Name for
your LAN.
Click <Apply> at the bottom of the screen to save the configurations.
You can now configure other advance sections or start using the router.