Melitta Caffeo CI - Manual (Page 13)

11
ENGLISH
• Fill the bean container (see page 11) and press the rotary switch to
confirm.
→ The prompt to fill the water tank will appear on the graphic display.
• Fill the water tank and reinsert it into the appliance (see page 12).
→ The rotary switch flashes and System Start appears on the graphic display.
• Place a vessel under the outlet and press on the rotary switch.
→ The appliance performs an automatic rinse and hot water flows out of
the outlet. The buttons are then illuminated. The appliance is ready for
operation.
4.4 Filling the bean container
Thanks to the 2-chamber „Bean Select“ bean container, you can use two different
types of coffee at the same time. For example, fill one chamber with espresso
beans, and the other with café crème beans. Then you can conveniently switch
between the two types using the tilt lever.
• Fill the bean container (Fig. A, No. 7) with fresh coffee beans. Each
of the two chambers can be filled with a maximum of 135 g of coffee
beans.
• Select the desired bean type by setting the tilt lever to the appropriate
chamber.
Warning!
Hazard for persons allergic to caffeine.
Since a residual quantity of the previously used beans remains above the
grinder, the two types of beans mix when changing to a different bean type.
Consequently, when switching over to decaffeinated beans the first two cups
may still contain coffee that is not decaffeinated. This means that only the third
cup of coffee prepared after the switchover is free of caffeine.
Caution!
– Fill the bean container with coffee beans only.
– Never fill the bean container with ground, freeze-dried, or caramelised
coffee beans.