Muratec F-116 - Manual (Page 84)

Alignment and Troubleshooting
4-24
LCD Display
Descriptions Solutions
[No Answer] The remote fax machine has not
answered after several redial
attempts.
Try again. Make sure that the remote
machine is operational.
[Incompatible]
The remote machine does not have
the requested feature, such as a
delayed transmission. It also occurs
if the remote machine does not have
enough memory space to complete
the operation you are attempting.
Reconfirm the remote machine’s
features.
Line Busy The remote person did not answer or
the line is already engaged.
Try again after a few minutes.
Power Failure
Power has turned off then on and the
machine’s memory has not been
saved.
You need to start again the job which
you were trying to do before the power
failure.
[Stop Pressed]
The Stop/Clear button is pressed
during a copy or fax operation.
Try again.
Memory Full
The memory is full. Delete unnecessary documents,
retransmit after more memory
becomes available or split the
transmission into more than one
operation.
CRU Fuse Error When the machine failed in installing
the new toner cartridge.
Open the front door and take out the
toner cartridge.
Then re-install it.
[Hsync Error]
Or
[LSU Error] When the machine has encountered
the LSU could not reach the READY
state.
Enter the EDC mode.(Refe to EDC
mode). And check the LSU
Control Test. If the LSU is defective,
replace it.
[Toner Low] Small amount of toner is left in the
cartridge.
The estimated cartridge life of toner is
close.
Prepare a new cartridge for
replacement. You may temporarily
increase the printing quality by
redistributing the toner.
Replace Toner
Small amount of toner is left in the
cartridge.
Replace the toner cartridge.
[Bypass Jam]
When the machine detected the non-
feeding from BYPASS tray.
Clear the JAM.
Group Not
Available You have tried to select a group
location number where only a single
location number can be used, such
as when adding locations for a
broadcasting operation.
Just use a one-touch or speed dial
number or dial a number manually
using the number keypad
Retry Redial ?
The machine is waiting for a specified
time interval to redial a previously
busy station.
You can press OK to immediately
redial, or Stop/Clear to cancel the
redial operation.