3Com 1000BASE-SX - Manual (Page 5)

9-Port 1000BASE-SX Gigabit Ethernet Layer 2 Switching Module Quick Start Guide 5
Unpacking
Instructions
Use the following procedure when you unpack the module:
1 Verify that the module is the correct model by matching the 3C number
that is listed on the shipping box label to the 3C number that you ordered
(Model Number 3CB9LG9MC).
2 Remove the module, in its antistatic bag, from the shipping box.
3 Observing the caution instructions, remove the module from its antistatic
bag and inspect it for physical damage.
CAUTION: Handle the module only by the front panel. Do not touch any
components, pins, leads, or solder connections.
If the module appears to be damaged, replace it in the antistatic bag, put
it back in the shipping box, and contact your network supplier.
4 Verify that the box also contains:
■
CoreBuilder 9000 Release Notes for the Fast Ethernet and Gigabit
Ethernet Layer 2 Switching Modules
■
9-Port 1000BASE-SX Gigabit Ethernet Layer 2 Switching Module
Quick Start Guide for the CoreBuilder 9000 Enterprise Switch (this
guide)
If the listed contents are not in your shipping box, contact your network
supplier.
All shipping boxes are reusable. After you remove the contents, replace
the packing materials and store the shipping box for future use.